E-Coating for Microchannel Coils Extends Corrosion Resistance to 2 000 Hours
Kaltra now applies e-coating for microchannel coils as a standard option for coastal, offshore and urban sites where chloride levels exceed 1 mg m⁻³. The process deposits 12 µm of cathodic epoxy onto every louvered fin and tube surface, bridging micro-gaps smaller than 5 µm and creating a continuous barrier against moisture and salt.
The coating cycle starts after vacuum brazing. Coils are degreased in alkaline solution, rinsed in de-ionised water and immersed in an epoxy bath kept at 28 °C and 200 V. Under the electric field, resin particles migrate to the aluminum surface and polymerise into a uniform film. A 20-minute bake at 180 °C cross-links the polymer, producing a glossy finish rated for 2 000 h neutral salt-spray per ASTM B117 and 1 kV salt-fog per IEC 60068-2-52.
Despite the added layer, air-side pressure rise remains below 3 Pa at 2.5 m s face velocity because the film conforms to louver edges without bridging them. Heat-transfer capacity drops less than 1 %, a figure already embedded in Kaltra selection software, so users receive validated ratings without manual derating.
E-coating for microchannel coils also survives 1 000 hours of condensing humidity at 40 °C and 95 % RH, making it suitable for tropical climates where conventional epoxy sprays fail at cut edges. The UV-stable top coat prevents chalking under 150 W m⁻² solar irradiance, maintaining emissivity below 0.2 and preserving the original aluminium colour for architectural façades.
Lead time is not affected: coated coils leave the Graz factory within ten working days, alongside uncoated batches. Kaltra sizes each unit through an AI portal that adjusts fin spacing and circuit length to offset the minor thermal penalty, ensuring COP targets are met while corrosion resistance is extended from 650 h to 2 000 h.
For operators, the upgrade translates into lower lifecycle cost: maintenance intervals double, repaint expenses disappear and coil replacement is postponed beyond the 20-year warranty period. The option is available on every Kaltra microchannel condenser, evaporator or water coil up to 6 000 mm length and 3 000 mm width, making e-coating for microchannel coils a one-click selection during online quotation.

